FT-850って、ゼネカバ改造できますか？ 瓜坊 2004/09/07 06:24:51 └Thismodificationisveryeasytopreform,howe... 英語だけどこの通りやってね 2004/09/08 08:38:20
| Re: FT-850って、ゼネカバ改造できますか？ [返事を書く] | ||
| This modification is very easy to preform, however do not force the radio apart !!!!!!!!!! Do not pinch any wires when taking it apart, do not turn any of the pots on the left side of the radio. Please, please use a very small soldering iron so you don't ruin your very nice radio !!!!!!! Here goes: Remove the power from the radio. Remove top and bottom covers. The next step is done temporarily. Locate jumper location JW3001 (solder pads) on the display unit and solder bridge the pads. Don't use too much heat The jumper is on the left side of the display board next to the left most CPU as looking from the back to the front with the radio in the normal up-right position. Reconnect the power. Press and hold [PROC], [AGC-F], [IPO], & [ATT] and turn the power on. You will now see 02 off Rotate the main dial until the display shows ( 02 - on ) Press [PROC]. This will confirm and write the data to the EEPROM memory. Turn the power off and disconnect the power cord. Remove the solder jumper that you made in step 3 above. Replace the covers. And again be careful that you do not pinch any wires and do not force it together. If you have any questions about this mod, EMAIL me at MarkC57 (AOL) or on internet at corcoran@ncube.com This is one fantastic radio and I would like to know what you think of yours. | ||
|
└有難うございました。参考にいたします。 瓜坊 2004/09/10 22:48:46
[「新」・ＣＢ無線・パーソナル無線・アマチュア無線・各種無線機改造情報・その他雑談掲示板]
[EXIT]
新規発言を反映させるにはブラウザの更新ボタンを押してください。