IC-731の27MHzの送信改造方法を教えて頂けませんでしょうか
IC-731の27MHzの送信改造方法を教えて頂けませんでしょうか ドンファン 2003/07/18 01:09:44
├BothmodsshownforIC735toopenupthetransmit... リセットは必要ないです（735でも同じ） 2003/07/19 10:47:15
|
Re: IC-731の27MHzの送信改造方法を教えて頂けませんでしょうか [返事を書く] |
Both mods shown for IC735 to open up the transmit frequencies say to clip diodes D33 and D34 on the "main board". This was a bad choice of words. In the IC735 service manual the big board you see when you open up the bottom of the case is called by Icom the "Main Unit" and it does have diodes marked D33 and D34. DO NOT CLIP THESE DIODES! Doing so will totally disable the XMIT function. You want to look at the PLL UNIT which is the board you see after lifting up the PA unit which is the heat sink unit you see when you first take off the TOP cover of the case. Clip D33 and D34 on the PLL BOARD. They are vertically mounted near the center of the PLL board and clearly marked by having bright yellow plastic "spaghetti" on the leads. This was done to make then easy to spot when converting the radio for MARS purposes and will no doubt be a popular mod for access to the new 60 meter band just authorized beginning in July. And, yes. I found this out the hard way.
|
| |
リセットは必要ないです（735でも同じ） 2003/07/19 10:47:15 |
|
│└こんばんは、ルパン三世さん。 ドンファン 2003/07/22 22:13:34
└上蓋をあけて、アンプを外し、基盤をだして... ルパン三世 2003/07/20 01:29:54
└すみません。返事の書き方がよく判らず、違... ドンファン 2003/07/22 22:18:50
└ルパン三世さん、出来ました！！ ドンファン 2003/08/14 22:50:40
[新 CB無線・パーソナル無線・各種無線機改造情報・総合掲示板＋α]
[EXIT]
新規発言を反映させるにはブラウザの更新ボタンを押してください。